Utilize the four RMP Backer Plates™ to secure a Vaultek® Slider Series - Mounting Plate to any RMP™ of sufficient size.
Assembly Tip: The tapped holes appear to be in the center of the RMP Backer Plate™ but they are just slightly off center. Let's call the side with the tapped holes being closer to the edge of the RMP Backer Plate™ the "Bottom Side". Place the RMP Backer PLates™ in a 3 x 3 MOLLE Spacing pattern. Make sure to flip all four RMP Backer Plates™ so that all of the "Bottom Sides" are facing inward toward each other, bringing the tapped holes as close together as possible. The square pattern of holes on the Vaultek® Slider Series - Mounting Plate (VESA 100MM) will fit at this point.
QTY 4 - RMP Backer Plate™
QTY 4 - #10 - 24 x 3/8" Machine Screw
Compatible with Vaultek® Slider Series - Mounting Plate